GeniusPro/Lightpalette Operator's Manual - Strand Lighting

510i Show Controller
displays each event and programmed event time in sequence as the light show progresses.
A < marker indicates the next event to trigger and a * marker indicates the last event triggered.
Select {EXT.CLK} to apply an external SMTE time code input via the 3-pin Audio XLR outlet.
Select {INT.CLK} to apply the internal time code clock.
The status of the timing source and SMPTE time is displayed on the LCD as EXTERNAL, OVERRIDE
(internal clock taken over),
NO CLOCK (external clock absent), INTERNAL or PAUSE).
Note: The time code source must be set to SMPTE at the Show Setup display before the internal or
external clock can be used.
This section covers the following topics:
■
■
■
Time Format
Setting/Resetting the Internal Clock
Stepping the Light Show Timing
Time Format
The time format for the internal clock is in the same format as the SMPTE input time code and is set at
Show Setup:
Form: HH:MM:SS:FF where
HH = Hours (0-23)
MM =- Minutes (0-59)
SS = Seconds (0-59)
FF = Frames per second (0-24, 0-25, 0-30 drop or 0-30 non-drop)
Setting/Resetting the Internal Clock
When the clock is INTERNAL or *PAUSED*, the {SET CLOCK} softkey may be used to display
alternative softkeys used to increment, decrement or reset the internal clock, as follows:
{+HH} Add one hour to the internal clock time.
{+MM} Add one minute to the internal clock time.
file:///C|/LIGHTP/HELP.ENG/page47.htm (6 of 10)11/2/2004 3:02:20 AM