GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Show Setup Screen
time, and stop date set to OFF.
To run a macro every day at specific times for a specific length of time, enter a start time and date, and
set the stop time and stop date to when you want the macro stopped. Leave interval set to OFF.
To run a macro at specific intervals forever, enter a start time and date, set the interval to the time you
want between repeats, and set the stop time and stop date to OFF.
To run a macro at specific intervals for a specific length of time, enter a start time and date, set the
interval to the time you want between repeats, and set the stop time and stop date to when you want
the macro stopped.
To run a macro only on specific days of the week during the times you have set above, uncheck the
days of the week on which you don’t want it to run.
MTWTFSS
The day of the week (or days) on which the macro will run. The value is tick (default) if enabled or _ if
disabled. The macro will be run each enabled weekday at the start time.
Start Time
The time of day to start the macro in 24 hour format. Can be OFF (the default) or any four digit time
value (0 is midnight, 1200 is midday and 2359 is 1 minute before midnight). If this is set to OFF the
macro is started at midnight on the date specified in the Start/DATE field.
Start DATE
The date and month to start the macro. Can be OFF (the default) or any four digit date/month number
from 0101 (1st January) to 3112 (31st December). The first digit can be omitted if it is 0 (101 is the
same as 0101). If this is set to OFF the macro is started today at the time specified in the Start Time
field.
Interval
The time between repetitions of the macro. Can be OFF (the default) or any four digit time value
between 0 and 23 hours, 59 minutes (2400). To run the macro once, set this to OFF. To run the macro
repeatedly between the Start Time/Date and the Stop Time/Date, enter the time desired between
repeats. To run the macro repeatedly forever, set a number in this field and set the Stop Time and
Stop Date fields to OFF.
StopTime
The time of day to stop the macro in 24 hour format. Can be OFF (the default) or any four digit time
value (0 is midnight, 1200 is midday and 2359 is 1 minute before midnight). If this is set to OFF the
macro is stopped at midnight on the date specified in the Start Date field.
Stop Date
The date and month to stop the macro. Can be OFF (the default) or any four digit date/month number
from 0101 (1st January) to 3112 (31st December). The first digit can be omitted if it is 0 (101 is the
same as 0101). If this is set to OFF the macro is stopped today at the time specified in the Start Time
field.
Macro
file:///C|/LIGHTP/HELP.ENG/page22.htm (9 of 10)11/2/2004 3:02:30 AM