GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Networker for SN10X Software Installation
Remote Install from an SN100/SN102
Ensure that the latest release is installed in the SN100/SN102
Type CTRL-X to abort from the Networker program back to DOS
Determine the IP address of the Networker you wish to update or the node name. Assume this
value to be ‘nodeid’.
Then type the following at the DOS prompt
COPY A:\REMSETUP.* D:\
IOFTPDOS LOGIN nodeid PUT d:\remsetup.z d:\remsetup.z
IOFTPDOS LOGIN nodeid PUT d:\remsetup.ins
c:\220os\install.bat
Then wait for at least 5 minutes, to ensure that the software has been installed in the remote
unit.
Remote Install from a PC
1. Ensure that the console has both Operating Software and Networker Utilities version 2.1
or later. All node types can be downloaded to - they are all referred to here as SN100.
2. Go to DOS at the console, and make a new directory C:\SN100. If it already exists,
delete its contents.
3. Copy the SN100 Operating Software floppy to C:\SN100
4. In C:\SN100, edit the file SW2ALL.BAT as follows:
Change
REM CALL SW2NODE NodenameORipAddress1
to
CALL SW2NODE sn100_1
CALL SW2NODE sn100_2
etc, where 'sn100_1' and 'sn100_2' are the network names of your SN nodes, as
defined in their 220node.cfg files, or as seen using the IOFTPDOS WHO
command.
5. If the node to be downloaded to is running v2.0 software, create a file called 220NODE.
CFG in the C:\SN100 directory, containing:
my_nodeaddr = 193.195.164.99
my_nodetype = IOFTP
my_nodename = IOFTP
6. Make sure the first 3 numbers match those of the node addresses. (You don't need to
do this step if the node has v2.1 or later.)
7. Run SW2ALL
8. A message saying Installation Successful appears on the PC
file:///C|/LIGHTP/HELP.ENG/page42.htm (4 of 6)11/2/2004 3:02:52 AM