GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Networker Software
For point to point communication, used for Tracking Backup, Multi-Console, Server and ShowNet
configuration, IP addresses are used and MUST be unique otherwise there will be an address conflict
and the network will fail. For advanced diagnostic and maintenance purposes unique addresses are
also required.
Default IP Addresses
Strand equipment is supplied from the factory with the following IP addresses:-
Equipment Type IP Address Net Mask
File Server (PC) 192.168.000.66 255.255.255.0
Backup (console or PC) 192.168.000.67 255.255.255.0
Main (console or PC) 192.168.000.68 255.255.255.0
Remote (console or PC) 192.168.000.69 255.255.255.0
SN100/102/103/104 Node 192.168.000.70 255.255.255.0
You can use these default addresses unless:-
●
●
You intend to use multiple MAIN, REMOTE or BACKUP consoles or PCs on the same network.
You intend to use ShowNet configuration software - in which case all SN10X node addresses
must be unique.
220node.cfg Network Configuration File
The 220node.cfg network configuration file is present on all nodes, consoles and PCs. You can edit it
using the DOS EDIT command to change many aspects of Networker operation. This is a sample
220node.cfg file from an 530 Console
# Copyright (c) Strand Lighting Ltd 1994-2000
# All rights reserved.
#
# Networker node configuration file
#
# @(#)220node.cfg 79.2
file:///C|/LIGHTP/HELP.ENG/page15.htm (3 of 23)11/2/2004 3:02:29 AM