GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Report Displays
Exit and System Shutdown
Important Note: You must always shut down the console using the correct procedure
described below. Do not shut down by simply switching off the console or isolating the
mains supply.
Before shutting down the console, you should make sure that you have saved the current
show by pressing {SAVE SHOW} {SAVE SHOW}. To shut down, press
{EXIT} {SHUTDOWN}. If you have not saved the show or the setup, a warning
will appear on screen. If you wish to save the setup or the show, press {SAVE SETUP} or
{SAVE SHOW}. Press {SHUTDOWN} again to shutdown the console. On 300 Series
consoles, the shutdown display will be shown, then the console will be shut down
automatically. On 500 Series consoles, the shutdown display will be shown telling you that you
may now shutdown the console. In the latter case, shut down the console using the On/Off
button on the console (530 and 550 consoles only) or the mains On/Off switch on the back of
the console (520 consoles).
file:///C|/LIGHTP/HELP.ENG/page46.htm (16 of 17)11/2/2004 3:03:04 AM