GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Working with Channel Levels (Cont)
●
increases their attribute levels by 1. To increase attribute levels on the current selection,
omit chans
[1] [@ATT] [NEXT] Direct 1 and 2 Digit
[1] [@ATT] [NEXT] [*] Command Line
Makes channel 1 the current selection and increases its attribute level by 1. For
example, if it was at 3 it is set to 4.
[@ATT] [NEXT] All Modes
Increases attribute levels of the current selection by 1.
chans [@ATT] [LAST] makes the specified channels the current selection and
decreases their attribute levels by 1. To decrease attribute levels on the current
selection, omit chans.
[1] [@ATT] [LAST] Direct 1 and 2 Digit
[1] [@ATT] [LAST] [*] Command Line
Makes channel 1 the current selection and decreases its attribute level by 1. For
example, if it was at 4 it is set to 3.
[@ATT] [LAST] All Modes
Decreases attribute levels of the current selection by 1.
Setting DMX Levels
Normally channel levels are set from 0% to 100%. However, the actual DMX level is an 8 bit
number ranging from 0 to 255. The {DMX} soft key lets you set channel levels and attributes to
exact DMX levels if necessary. For attributes you must use the chan [.] att format to specify
the attributes you want to change. The [@ATT] key does not let you set channels to DMX
levels.
Setting actual DMX levels gives you more precise control over the levels you set. The display
will show the nearest standard (00 to FL) level rather than the exact DMX level you set.
●
chan [.] att [@] {ENABLE}{DMX} # [*] makes the selected channels or attributes the
current selection and sets their levels to the specified DMX level. To set the current
selection, omit chans.
[1] [THRU] [3] [@]] {DMX} [1] [2] [8] [*] All Modes
Sets the intensity for channels 1, 2, and 3 to DMX level 128 (50%). The display will show
50.
[1] [.] [2] [+] [2] [.] [2] [@] {DMX} [5] [6] [*] All Modes
Sets the colour attribute for channels 1 and 3 to DMX level 56. The display will show the
frame number, which is 2 if the maximum number of frames for the attribute is 10.
file:///C|/LIGHTP/HELP.ENG/page50.htm (6 of 11)11/2/2004 3:02:45 AM