GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Channel levels, attributes and Dimmers cl mode QR
[1] [THRU] [5] [@] [CUE] [2] {INTS
ONLY} [*]
[CUE] [1] [*]
[SUB] [1] [*]
[GROUP] [1] [*]
Chans 1 > 5 Ints only copied from
cue 2
Select IntChans from (cue 1) at
current levels
IntChans from cue 1 are wheeled
[CUE] [1] wheel
using wheel mode from current levels
to recorded levels, as recorded fade
type
IntChans in cue 1 are wheeled from
[CUE] [+] [1] wheel
current levels to levels recorded in
cue 1as a move fade.
[CUE] [-] [1] wheel
IntChans in cue 1 are wheeled from
current levels to zero (dim fade 0)
[+] [1] Add channel 1 to current selection
[-] [1]
Removed channel 1 from current
selection
[1] [HOLD] Holds channel 1
[1] [SHIFT] [HOLD] Un-holds channel 1
[SHIFT] [HOLD] [HOLD]
(No channels selected) Un-holds all
held channels
Fading in Intensity Channels in Time
The following Command Line syntax examples are normally used with Lightpalette
Key Sequence Action
Set channels 1 to 3 inclusive from
[1] [THU] [3] [@] [5] [TIME] [5] [*] current level to 50% over a period of
5 seconds.
Sets channels 3 from current level to
[3] [@] [5] [TIME] [*]
50% over a period determined by the
setting of the Undo Time.
Controlling Attributes (Command Line Mode)
file:///C|/LIGHTP/HELP.ENG/page55.htm (4 of 8)11/2/2004 3:03:28 AM