GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Console Setup
CommuniquéPro software is loaded. It cannot be set to the same port as the Handheld Remote. For
more information refer to CommuniquéPro
GO Key Output
Sets the status and the serial port that the GO Key output is connected to and is only used when the
CommuniquéPro software is loaded. It cannot be set to the same port as the Handheld Remote. For
more information refer to ASCII Remote Go Output
Macro Trigger Output
Sets the status of the serial port that the macro trigger output is connected to and is only used when
the CommuniquéPro software is loaded. For more information refer to ASCII Remote Control Output
Remote Test
This is only used for factory testing and should always be set OFF.
Audio Input Macro
Sets the macro that will be run from the audio bass beat and is only used when the CommuniquéPro
software is loaded. For more information refer to Audio Input Macro
Remote Trigger Macro
The macro that will be run from the Remote Control Input and is only used when the CommuniquéPro
software is loaded. For more information refer to ASCII Remote Control Input
Trigger Bytes
These three fields are only used when the CommuniquéPro software is loaded. Refer to MIDI Trigger
Macro for more detail.
External Submasters Window
The External Submasters window is in the Console Setup display, and lets you configure which
internal submasters are run by the external submasters. The node address of up to 12 external
submasters can be set in this window. In addition a scaling factor of between 80 and 120% can be
file:///C|/LIGHTP/HELP.ENG/page31.htm (6 of 7)11/2/2004 3:02:27 AM