GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Working with Channel Levels
●
●
●
[1] {THRU ON} [3] Adds channels 1, 2, and 3 to the channel list if they are on[NEXT]
and [LAST] can be used when selecting a cue, group, effect step, or submaster to
select the item after or before the current cue, group, effect step, or submaster. The
current cue, group, effect step, and submaster are shown on the right LCD.
[SUB] [NEXT] Adds channels recorded in the submaster after the current submaster to
the channel list.
[CUE] [LAST] Adds channels recorded in the submaster before the current submaster
to the channel list.
{THRU ON} is most often used to adjust the level of all lights that are on in a given cue.
The designer may require all on light to be increased (or decreased by, say 5%). This is
easily achieved by the commands [GOTO] [CUE] # and # [THRU] # {THRU ON} {UP%}
or {DOWN %} (the Up and Down % value is set in the Up Down % field of the User
Setup Screen
Current Channel Selection
The Channel Control only modifies channels in the current selection. The channels in the
current selection are shown on the Live display with a red background (white text). (see also
Extending the Current Selection) To select channels you specify the selection as shown above
and then press [*].
●
●
●
●
chan [*] makes the specified channels the current selection
[1] [+] [2] [*] Select channels 1 and 2 at their current levels.
[*] makes all channels which are on (those above 0 or on At 0) the current selection.
This is the same as [1] {THRU ON} [9] [9] [9] [9] [*]
[*] Select all on channels.
Extending the Current Channel Selection
●
●
●
[+]chan [*] or [-] chan [*] add or subtract channels from an already existing channel
selection.
[+] [4] [THRU] [9] [*] Adds channel 4 through 9 to the existing channel selection.
[-] [4] [5] [*] Subtracts channel 45 from the existing channel selection.
file:///C|/LIGHTP/HELP.ENG/page5.htm (7 of 13)11/2/2004 3:02:44 AM