GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Designer Remote
Designer's Remote
This section refers to the Designer's Remote for use with the Strand 300, 400, and 500 series consoles
and GeniusPro or Lightpalette software:
Installing the Designer's Remote
Plug wired remote into console Aux port (only AUX3 is allowed on older consoles).
At Console Setup Screen set “Handheld Remote” to DESIGNERS and set the Net Node, Port, Config
and Address for the remote. (Refer to Handheld Remote Communications Setup)
1. Display will illuminate and keys become active.
2. Channels under remote control will be displayed in purple on console screens.
3. To alter the display contrast use the thumbwheel on the right-hand side of the unit.
Operating the Designer's Remote
Operation of the Designer's Handheld Remote uses the same syntax as the command line on the main
console. A few examples of commands when the console is set to Command Line mode are shown
below.
Refer to Alternative keys to use the alternative function for keys having a function, in blue, above the
main key function in grey.
Note: From Version 2.4, the F1 to F4 keys on all handhelds will fire pre-assigned macros HHM1 to
HHM4 (Refer to Pre-Assigned Macros
file:///C|/LIGHTP/HELP.ENG/page19.htm (1 of 3)11/2/2004 3:02:59 AM