GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Patches
Moving Patch Information
Press {SET} from the LCD Patch Menu to display the LCD Set Patch Menu. Press {COPY/
SWAP} to display the Copy Patch Menu.
Moving Attributes
Enter the output number, or range of outputs, of the attribute to be copied, followed by the
{MOVE PATCH} softkey and the output number where the attribute(s) has to be moved to,
then [*].
A confirmation is requested after each command. Press [*] again.
[1] {MOVE PATCH} [1] [0] [@PATCH] [2] [*]
Moves attribute 1 to output 10 on the non-edit patch screen.
[1] [THRU] [10] {MOVE PATCH} [1] [1] [*]
Moves attributes on outputs 1 to 10 to outputs 11 to 20.
Press {BACK} to return to the LCD Set Patch Menu.
Moving Fixtures
Enter the first output number of the attribute to be copied, followed by the {MOVE PATCH}
softkey and the first output number where the fixture has to be copied, then [*].
[2] [2] {MOVE PATCH} {4] [4] [*]
Moves the fixture starting on output 22 to start on output 44.
[2] [2] [THRU] [5] [2] {MOVE PATCH} [5] [4] [*]
Moves the fixtures patched to outputs 22 to 52 to start on output 54.
Press {BACK} to return to the LCD Set Patch Menu.
Swapping Patch Information
Swapping Attributes
Press {SET} from the LCD Patch Menu to display the LCD Set Patch Menu. Press {COPY/
SWAP} to display the Copy Patch Menu, then enter the output number, or range of outputs, of
the attribute(s) to be swapped, followed by the {SWAP PATCH} softkey and first output
number of the attribute to be swapped with, then [*]. A confirmation is requested after each
file:///C|/LIGHTP/HELP.ENG/page9.htm (11 of 21)11/2/2004 3:03:09 AM