GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Effects
This field can be set in edit mode using the trackball to select the field and the level wheel or [+] or [-]
keys to select the option. Alternatively, the field can be set using the command line as shown in the
following example:
[FX] [1] [PROFILE] [3] [*]
Sets FX 1 overall fade profiles to 3
Stop After
The Stop After property determines what happens when you press [FX STOP]. This property can only
be changed from the Effects display, and is initially set to FX STOP.
FX STOP
The effect stops and is unloaded when you press [FX STOP] for its effect playback.
FX LOAD
The effect is not unloaded until another effect is loaded onto the same effect playback. The effect is
only paused when you press [FX STOP]. You can then press [FX GO] to restart the effect.
LAST STEP
When you press [FX STOP], the effect continues to run normally until it reaches the last effect step. It
then fades out and stops in the time specified by the Fade Dn field (or cue or submaster
time).
CYCLES
The effect stops after the number of cycles specified in the Cycles field.
TIME
The effect stops after the amount of time specified in the Time field. You can enter values in the range
0.01 seconds to 59.59 seconds (refer to Effect Fade Times)
This field can be set in edit mode using the trackball to select the field and the level wheel or [+] or [-]
keys to select the option. Alternatively, the field can be set using the command line as shown in the
following examples:
[FX] [1] {STOP AFTER} [FXLOAD] [*]
Sets FX 1 to stop only after next Fx loaded
[FX] [1] {STOP AFTER} [1] [2] [*]
Sets FX 1 to stop after 12 complete cycles
file:///C|/LIGHTP/HELP.ENG/page35.htm (9 of 34)11/2/2004 3:03:13 AM