GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Effects
You can also stop and unload all effects from all playbacks using the syntax:
[FX] [0] [FX GO] All Modes
The following alternative commands apply to 500 series consoles.
[FX] [0] [PB] [2] [FX LOAD] Direct Entry 1 and 2 Digit
[FX LOAD] [0] [PB] [2] [*] Command Line
Selects playback 2 and unloads the effect from it (if any).
[FX] [0] [FX LOAD] Direct Entry 1 and 2 Digit
[FX LOAD] [0] [*] Command Line
Unloads all effects from all playbacks.
[FX LOAD] [0] [PB] [2] [*] Direct Entry 1 and 2 Digit
Selects playback 2 and unloads the effect from it (if any)..
Using Effects in Cues and Subs
You can control effects with cues by assigning the effect to one cue for starting and a different cue for
stopping. For information on assigning effects to cues, turn to Assigning an Effect in Recording Cues
Note: Stopping an effect from a cue with zero fadeout time sometimes causes the effect to step on one
more step after being stopped. Use a 2-part cue with a 0.1s delay between parts. The earlier part
stopping the effect and the later part setting the required cue level.
You can control effects with submasters by assigning the effect to a submaster. Moving the submaster
away from zero starts the effect and moving it back to zero stops the effect.
Viewing and Editing Effects
Once you have recorded effects, you can view and edit them in the Effect display. You can also use
the Effect display to create new effects.
The following topics are covered in this section:
file:///C|/LIGHTP/HELP.ENG/page35.htm (25 of 34)11/2/2004 3:03:13 AM