GeniusPro/Lightpalette Operator's Manual - Strand Lighting

510i Show Controller
{SHUTDOWN} Displays warning/confirm message. Press {SHUTDOWN} to shut down the system or
the [CLR] key to cancel.
Error Line
Text, that would appear on the error line of a 500 Series, or 310 video monitor is displayed on the 510i,
or 310 LCD display. Pressing the [CLR] button cancels the error message.
Off Line Editor
The 510i and 310 incorporates the GeniusPro and Lightpallette Off-line Editor and PC Software,
providing full emulation of the 500 Series, or 300 Series console operating software on a standard PC.
Submaster Macro Inputs
Forty-eight submaster macro inputs are provided via four 25-pin female D type sockets on the back of
the 510i panel. Twenty-four submaster macro inputs are provided via two 25-pin D-type sockets on the
back of the 310 panel. These inputs provide simple On/Off logic switching and are designed to act
functionally as individual submaster bump buttons. Each input can be used to trigger a macro or an
effect.
To use these inputs to trigger macros, their corresponding submasters must either have the bump field
set to Mac (Macro) (recommended), or have an external submaster assigned in the Ext field.
Each of the 48 (24) submaster macro inputs consist of a signal/ground pair on adjacent pins of a D
type connector. The required number of contact closure devices are coupled to the connector(s) using
twisted pair cables. It is recommended to use 24AWG twisted pair wires for each contact. CAT5 UTP
cable is suitable.
510i an 310
Sub 1-12 macros
Pins 1 to 12 Submaster 1 to 12 macros
Pins 13 to 25 Ground
Pins 1 to 12 Submaster 13 to 24 macros
file:///C|/LIGHTP/HELP.ENG/page47.htm (9 of 10)11/2/2004 3:02:20 AM