GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Recording Cues
attributes without changing recorded levels. If the cue doesn’t exist, this command
creates a new cue with no levels but with the specified attribute fade time
assigned. You do not get an overrecord warning with this command if the cue
exists.
[CUE] [1] [@ATT] [TIME] [5] [*] All Modes
Changes the attribute fade time for cue 1 to 5 seconds without changing any
levels or other cue properties.
See also Fade Time
Assigning Fade Profiles to Attributes
You can assign a profile to the attribute change for the cue.
[RECORD] cue [@ATT] [PROFILE] # [RECORD] [*] records the levels on the current display
into the specified cue and assigns a fade profile for attribute changes in the cue. If the cue
already exists, an overrecord message gives you the chance to cancel the recording. To
rerecord the cue, press [RECORD] [*] again. To cancel the recording, press [CLR] or [UNDO].
For information on creating and editing profiles, refer to Profiles
Separate fade profiles can be assigned to each cue part for attributes. To delete an assigned
fade profile, omit the fade profile number.
[CUE] [1] [@ATT] [PROFILE] [3] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [@ATT] [PROFILE] [3] [*] Command Line
Records levels into cue 1 and assigns fade profile 3 to the attributes.
[CUE] [1] [@ATT] [PROFILE] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [@ATT] [PROFILE] [*] Command Line
Records levels into cue 1 and deletes any fade profile assigned to attributes.
cue [@ATT] [PROFILE] # [*] changes the fade profile assigned to the specified cue’s
attributes without changing recorded levels. If the cue doesn’t exist this command
creates a new cue with no levels but with the specified fade profile assignment. You do
not get an overrecord warning with this command if the cue exists.
[CUE] [1] [@ATT] [PROFILE] [*] All Modes
file:///C|/LIGHTP/HELP.ENG/page45.htm (10 of 22)11/2/2004 3:02:32 AM