GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Running Cues
appropriate [RATE] key to end the rate adjustment and return the wheel to the normal level function.
Changing the current fade rate does not change the recorded fade time for any cues or parts. Rather, it
changes the time remaining for cues that are running when you press [RATE]. If there is more than
one cue or cue part running when you press [RATE], the Level Wheel changes their fade rates
proportionally.
The Level Wheel loses control of fades when all fades are completed, or when a new fade is started.
Rate changes you made with the Level Wheel still apply to running cues or parts, but the Level Wheel
no longer controls any fades.
Cue Fade Progress in Manual Time
Normally cue fades progress automatically. Manual Time takes the fade times of all currently running
cues and the next cue on the Playback from the time fader. The next cue is adjusted to the exact value
of the time fader, and the currently running cues are adjusted proportionally to their current percent on
completion. The up and down times can be controlled separately.
Any new cues automatically come under control of the fader and take their time from the time controls.
To change the playback faders into time controls, press {MAN TIME} over the playback. The LCD
changes to {AUTO}, {INST} and {MAN FADE} in this mode. The time for the fade will now be taken
from the playback faders acting as time controls. The scales for time are on the outside of the two
faders and are marked from 0 to infinity
To instantly complete a fade, press {INST}.
To return to normal mode where the fades continue automatically, press {AUTO}. Changes made
while you were in Manual Time mode remain on the fader but all new cues will be run using their
recorded times.
Updating and Adding To Cues
[UPDATE] cue # [*] changes levels in the specified cues as necessary based on
channels that have been modified including channels that are not already in the cues.
Channels that are off in the selection are removed from the cues. The cues must already
exist.
file:///C|/LIGHTP/HELP.ENG/page7.htm (12 of 25)11/2/2004 3:02:36 AM