GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Working with Channel Levels
Setting Levels With the Keypad
Channel levels can be set directly from the command line by using the Levels keypad to select
channels and specify levels.
chans [@] # [*] selects the listed channels and sets their intensity levels to the specified #
level. To set levels for the current selection, omit chans.
[1] [@] [0] [.] [1] Direct 1 Digit
[1] [@] [0] [1] Direct 2 Digit
[1] [@] [0] [1] [*] Command Line
Makes channel 1 the current selection and sets its level to 1%.
[1] [+] [3] [@] [1] Direct 1 Digit
[1] [+] [3] [@] [1] [*] Direct 2 Digit
[1] [+] [3] [@] [1] [*] Command Line
Selects channels 1 and 3 and sets their levels to 10%.
[@] [1] [.] [1] Direct 1 Digit
[@] [1] [1] Direct 2 Digit
[@] [1] [1] [*] Command Line
Changes the levels of the current selection to 11%.
chans [@] [+] # [*] selects the listed channels and increases their intensity levels by the
specified # level. To set levels for the current selection, omit chans.
[1] [@] [+] [1] Direct 1 Digit
[1] [@] [+] [1] [0] Direct 2 Digit
[1] [@] [+] [1] [*] Command Line
Makes channel 1 the current selection and increases its level by 10%. For example, a channel
at 55% would go to 65%. Any levels over 100% are limited at 100%.
[@] [+] [1] [.] [1] Direct 1 Digit
[@] [+] [1] [.] [1] Direct 2 Digit
[@] [+] [1] [1] [*] Command Line
The existing current selection is unchanged but their levels are increased by 11%.
chans [@] [-]# [*] selects the listed channels and decreases their intensity levels by the
specified # level. To set levels for the
current selection, omit chans.
[1] [@] [-] [1] Direct 1 Digit
[1] [@] [-] [1] [0] Direct 2 Digit
[1] [@] [-] [1] [*] Command Line
Makes channel 1 the current selection and decreases its level by 10%. For example, a channel
at 55% would
go to 45%. Any levels under 0% are limited at 0.
file:///C|/LIGHTP/HELP.ENG/page5.htm (9 of 13)11/2/2004 3:02:44 AM