GeniusPro/Lightpalette Operator's Manual - Strand Lighting

R130 Handheld Remote
Installing the R130 Radio Base
1. Write down serial number of base station xxxxxxxx - you will need it later.
2. Connect PSU to base station & red power LED will illuminate.
3. Plug radio base station into console Aux port (only AUX3 is allowed on older consoles).
4. At Console Setup screen, Handheld Remote Communications Setup, set “Handheld Remote” to
“R130 Radio” and set and set the Net Node, Port, Baud Rate. Set the configuration address (8
digit number, up to 4 digits In the left field and 4 digits in the right field) to “Internal Radio Sn”
previously recorded.
R130 Base Pinouts
6 pin XLR male RS232 Signal Name
Pin 1 Ground & Screen
Pin 2 +10V Power Input
Pin 3 N/C
Pin 4 N/C
Pin 5 RX [data to base/handheld]
Pin 6 TX [data from base/handheld]
Operating the R130 Handheld Remote
Examples of basic operation when in Single Digit Direct Entry mode are given below. For further
details regarding specific commands, refer to the appropriate section in the Table of Contents or Index.
Level Setting
[1 ][@][ 5] Direct 1 Digit
[1][@][50][*] Command Line
channel 1 at 50%
[2][+][9][@][4] Direct 1 Digit
[2][+][9][@][4][0][*] Command Line
channels 2 & 9 at 40%
[9][THRU][1][2][@][4] Direct 1 Digit
[9][THRU][1][2][@][4][0][*] Command Line
channels 9 thru 12 at 40%
file:///C|/LIGHTP/HELP.ENG/page38.htm (3 of 4)11/2/2004 3:02:59 AM