GeniusPro/Lightpalette Operator's Manual - Strand Lighting

X Playbacks
The playbacks can be used from any display.
The X Playbacks window in the Live display State screen and the left LCD show the current
state of each of the playbacks.
X Playback LCD
The X Playback LCD shows the current cue being run and the wait, delay or fade time for each
playback. This information is duplicated from the Live display. In addition, the LCD shows the
current playback mode as selected by the soft keys below the LCD. If the cue is fading it
shows AUTO FADING, MAN TIMING, or MAN FADING. If the cue has completed it shows
AUTO, MAN TIME, or MAN FADING. If the cue is stopped it shows STOPPED, MAN TIME
STOP, or MAN FADE STOP.
X Playback in Manual Fade Mode
To change the playback to Manual Fade mode, press {MAN FADE}.
Normally cue fades progress automatically. Manual Fade takes the current fade progress from
the progress faders for the last fade on the playback. The scale for fade progress is between
the two playback faders, and is marked from 0% to 100%. The left fader controls up fades and
the right fader controls down fades.
Going to Manual Fade mode stops the fades. The fader must be moved to 0, then moved to
pick up the current position of the cue after which it moves the progress between 0% and
100%.
When the fade reaches 100% the fader loses control of it. Moving both faders to 0% then
starts the next cue running. Any cue wait or delay times are ignored. This automatic
sequencing can be turned off.
To change to Manual Fade mode, press {MAN FADE} above the playback. The up and down
fade progresses are controlled by the faders. The LCD changes to {AUTO}, {MAN TIME} and
{SEQ}.
file:///C|/LIGHTP/HELP.ENG/page32.htm (6 of 7)11/2/2004 3:02:37 AM