GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Submasters
Two-Scene Preset
When set to Two Scene Preset Mode, half of the channel faders are controlled by the Preset 1 fader
and the other half by Preset 2 fader. Similarly, the fade times for each scene are controlled by the time
faders. A dipless cross fade between scene 1 and scene 2 is achieved by moving both Preset Faders
together. Scene 1 is indicated on 300 Series consoles by a red LED. Scene two is indicated by a green
LED. Both scenes are indicated by green LEDs on 500 Series consoles.
You can set the fade time between 0 and 59min, 59 secs for Preset 1 and Preset 2 using the X2 faders
on 500 Series consoles or the separate time faders on 300 Series consoles. When set to zero, the
fade time is governed by the rate at which the Preset 1 and Preset 2 faders are moved manually.
When set to a value greater than zero, the fade time for each Preset Fader is the individual fade times
set by the time faders.
file:///C|/LIGHTP/HELP.ENG/page24.htm (24 of 25)11/2/2004 3:02:50 AM