GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Console Reporter
Note: Alternatively, you can remove some of the filters from an output, while retaining others, by using
the [-] key, as shown:
[DIMMER] [6] {FILTER} [-] {LOAD LIMIT} [*]
Removes the load limit filter from output 6 (All Modes)
Pressing {DIMMER LOG} {OUTPUT FILT} shows the Output Filter screen. This screen
shows a list of fault types that have been filtered out for particular outputs. The output numbers are
listed down the left-hand column and filtered out faults for each output are indicated by a yellow tick
under the particular fault type.
Recording a Dimmer Backup Scene
This Reporter feature enables a backup scene to be recorded. In the event of a major failure, the
dimmer backup scene can then be set manually from the dimmer rack. Up to 99 different backup
scenes can be recorded. The following examples show how to set a backup scene for a dimmer rack:
[DIMMER] {BACKUP} [8] [RECORD]
Records the dimmer backup scene 8 for all racks (Direct Action Mode)
[RECORD] [DIMMER] {BACKUP} [8] [*]
Records dimmer backup scene 8 for all racks (Command Line Mode)
You can also record a backup fade time within a backup command, as shown:
[DIMMER] {BACKUP} [8] [TIME] [5] [RECORD]
Records dimmer backup scene 8 and sets a fade time of 5 seconds (Direct Action Mode)
[RECORD] [DIMMER] {BACKUP} [8] [TIME [5] [*]
Records dimmer backup scene 8 and set a fade time of 5 seconds (Command Line Mode)
[GOTO] [DIMMER] {BACKUP} [8] [*]
Instructs all dimmer racks to fade to the backup scene 8 in the recorded fade time (All Modes)
file:///C|/LIGHTP/HELP.ENG/page11.htm (7 of 8)11/2/2004 3:03:05 AM