GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Profiles + Macros QR
Profiles and Macros
Recording and Editing Profiles (Command Line Mode)
The following Command Line syntax examples are normally used with Lightpalette
On any window:
n
Key Sequence Action
[PROFILE] [1] [*]
Select profile 1 for edit, create if absent
[PROFILE] [1] [TEXT] hello [*] Set profile text to 'hello'
[DELETE] [*]
Delete selected profile
[DELETE] [2] [*]
Delete profile 2 if present
[DELETE] [1] [THRU] [6] [*] Delete profiles 1 thru 6 if present
Add a new point at (x = 15%, y = 20%).
[1] [5] [@] [2] [0] [*]
If x = 15% already has a y value, the new
value takes its place.
Add a new point at (x = 15%, y = 100%).
[1] [5] [@] {FULL}[*]
If x = 15% already has a y value, the new
value takes its place.
[1] [5] [@] {DMX}[2] [5] [5] [*] Add a new point at (x=15%, y=255).
[1] [5] [@] [*] Delete point at (x=15%)
{DMX} [5] [0] {DMX} [2] [5] [5] [*] Add a new point at (x=50, y=255).
{DMX} [5] [0] [*]
Delete point at (x=50)
At profile window:
{GRAPH EDIT}
Start graph-editing the selected profile
with the track ball or mouse
At graph window:
{END EDIT}
End graph-editing the selected profile
{INSERT POINT}
Insert a new point at the track ball or
mouse cursor
{DELETE POINT}
Delete the nearest point to the track ball
or mouse cursor
[RECORD] [PROFILE] [1] [*]
Records profile 1 using current profile
points
[UNDO] [RECORD]
Undo record command
[SHIFT] [RECORD]
= [UNDO] [RECORD]
[+] Increased selected point by 1%.
file:///C|/LIGHTP/HELP.ENG/page68.htm (1 of 5)11/2/2004 3:03:35 AM