GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Running Cues
A cursor (>) shows the current cue. This is the cue that will be recorded if you use recording
commands and do not specify a cue number. It is also the cue that will appear when you press
to see the Preview display and LCD menu.
●
●
●
●
●
When you record a new cue the cursor moves to the newly recorded cue.
When you load a cue onto a playback, the cursor moves to the loaded cue.
When you shift into the live display the cursor moves to the last completed cue or, if a cue is in
progress, to the cue in progress.
When you press [GO] or [STOP BACK] the cursor moves to the cue in progress.
When you press [NEXT] or [LAST] with no channels selected, or B or C on the playbacks, the
cursor moves to the next or last existing cue. The cursor ( > ) on screen next to the cue number
shows the current cue.
With dual playbacks, each playback has its own current cue.
The examples shown immediately below are command segments you can use to select a cue number.
You can then use combinations of these command segments to replace cue where it appears in full
command descriptions.
Note: Since the following examples form only part of a command, they are not related to channel
control mode and the final [*], where appropriate, is not shown.
[CUE] {PART} # specifies the current cue with a specific part number.
[CUE] Specifies the current cue part 1.
[CUE] {PART} [2] Specifies the current cue part 2.
[CUE] [CUE] # Specifies the current cue with a specific part number.
[CUE] [CUE] [2] Specifies the current cue part 2.
[CUE] # {PART} # Specifies a specific cue.
[CUE] [1] Specifies cue 1 part 1.
[CUE] [1] {PART} [2] Specifies cue 1 part 2.
[CUE] [1] [.] [2] {PART} [3] Specifies cue 1.2 part 3.
[CUE] [NEXT] {PART} # specifies the next cue after the current cue. If the current cue is the
highest cue number, this specifies the lowest cue number.
[CUE] [NEXT] Specifies the cue part 1 after the current cue.
[CUE] [NEXT] {PART} [2] Specifies the cue part 2 after the current cue.
[CUE] [LAST] {PART} # Specifies the previous cue before the current cue. If the current cue is
the lowest cue number, this specifies the highest cue number.
[CUE] [LAST] Specifies the cue part 1 before the current cue.
[CUE] [LAST] {PART} [3] Specifies the cue part 1 before the current cue.
file:///C|/LIGHTP/HELP.ENG/page7.htm (2 of 25)11/2/2004 3:02:36 AM