GeniusPro/Lightpalette Operator's Manual - Strand Lighting

CommuniquéPro
channels.
The Notes field in the MIDI window of the SHOW SETUP screen can be set as follows.
OFF Any received Note On or Note Off is ignored.
FADERS The Note number matches faders 1 to 12.
SUBS All Note On/Off messages will cause a Submaster to be flashed.
ssed) of the MIDI note message is acted upon. When Velocity is OFF, any velocity greater
than 0 is treated as full on, and 0 is off. When Velocity is ON the velocity determines the
The Velocity option determines if the velocity (strength at which a key is deprelevel to which
the bump key is flashed: press a key hard the level is high, press a key lightly and the level is
low.
MIDI Messages
This section is for experienced MIDI programmers only.
Control Change
Consists of two General Purpose Controllers, 1 for faders the other for keys. General Purpose
Controller 1 MSB (Controller 10h) and LSB (controller 30h) is used for faders and General
Purpose Controller 2 MSB (Controller 11h) and LSB (controller 31h) is used for keys.
Message Bytes Lighting Event Dir
Bn 10 01 30 xx … Bn 10 78 30 xx Channel/Submaster Fader 1…120 r,t
Bn 10 79 30 xx X1 Up Fader r,t
Bn 10 7A 30 xx X1 Down Fader r,t
Bn 10 7B 30 xx X2 Up Fader r,t
Bn 10 7C 30 xx X2 Down Fader r,t
Bn 10 7D 30 xx Grand Master 1 Fader r,t
Bn 10 7E 30 xx Grand Master 2 Fader r,t
Bn 10 7F 30 xx undefined -
Bn 11 00 31 xx MIDI Beat Event r,t
Bn 11 01 31 xx MIDI Trigger Event r,t
Bn 11 02 31 xx Bump Key r,t
Bn 11 03 31 xx Bump Key Up r,t
file:///C|/LIGHTP/HELP.ENG/page8.htm (8 of 22)11/2/2004 3:02:24 AM