GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Working with Channel Levels
chans [@] [*] or chans [@] [.] [*] or chans [@] {OFF} [*] selects the listed channels and sets
their intensity levels to off. To set levels for the current selection to off, omit chans.
[1] [@] [*] All Modes
[1] [@] [.] Direct 1 and 2 Digit
[1] [@] [SHIFT] Direct 1 and 2 Digit
[1] [@] [.] [*] Command Line
[1] [@] {OFF} [*] Command Line Makes channel 1 the current selection and sets its level off.
Note:If you use this command in the Live display when Tracking is on, it sets
channel levels to zero. If you record these channels, a zero level is recorded in
the cue only if levels changed from previous cues. Otherwise off is recorded in the
cue, and levels track through from the previous cue. If you use this command in
the Cue/Preview display, the channels appear at their levels from the previous
cue since turning a channel off (rather than setting it to zero) makes it track.
chans [@] [0] [*] selects the listed channels and sets their intensity levels to zero. To
set levels for the current selection to zero, omit chans.
[1] [@] [0] Direct 1 Digit
[1] [@] [0] [0] Direct 2 Digit
[1] [@] [0] [*] Command Line
Makes channel 1 the current selection and sets its level on at 0.
Note: If you use this command in the Live display when Tracking is on, it sets
channel levels to zero. If you record these channels, a zero level is recorded in
the cue only if levels changed from previous cues. Otherwise off is recorded in the
cue, and levels track through from the previous cue. If you use this command in
the Cue/Preview display the channels are forced to zero and tracking for those
channels is blocked at the cue
chans [REM DIM] selects the listed channels and sets all other intensity channels to
0%. If the selected intensity channels are all at 0, they are set to the on level as set in
the Setup display.
This feature is useful if a designer wants to check the focus of one or more lights. By
selecting the light(s) to be checked and pressing [REMDIM], the selection is
immediately set to the On value (default 100%) with all other lights switched off.
file:///C|/LIGHTP/HELP.ENG/page5.htm (11 of 13)11/2/2004 3:02:44 AM