GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Macros
INTUOS A4
OS
MACRO
(HIGH)
40 x 32 1280
INTUOS A3 MACRO (LOW) 20 x 20 400
INTUOS A3 MACRO (MED) 20 x 40 800
INTUOS A3
MACRO
(HIGH)
40 x 40 1600
Fitting the Macro Tablet Template
1. Insert template under protective screen.
2. The top of the template should align with the bottom of the Graphic Tablet "Quick Point Area".
3. The top markers on the template should align with the markers on screen.
4. This gives left/right alignment only.
5. Let the template and protective screen drop down
6. The crosshair markers in the lower section of the screen should align with the template,
although some fine adjustment may be required.
Using the Macro Tablet
The top left macro button on all macro tablet overlays is pre-defined as Macro number 1001. All other
macro tablet buttons are pre-defined in rows from left to right, so the bottom right macro button on a
1600 macro overlay is Macro 2600.
You can activate each macro simply by touching the macro button using the macro tablet pen, or
pointing device. This is the same as pressing the [MACRO] button on the console, followed by the
macro number.
Defining, Learning, Editing and Deleting Macro Tablet Macros
Macros assigned to the macro tablet are defined, learned, edited and deleted in the same way as
macros assigned to the console. Refer to instructions contained in this section.
Top of Page
file:///C|/LIGHTP/HELP.ENG/page30.htm (9 of 10)11/2/2004 3:02:58 AM