GeniusPro/Lightpalette Operator's Manual - Strand Lighting

R120 Handheld Remote
❍
Operating the R120 Handheld Remote
Installing and Configuring the R120 Handheld Remote
This section describes the installation and configuration of the following:
■
■
■
■
Installing the R120 Wired Remote
Installing the R120 Radio Base
Installing the R120 Radio Handheld Remote
R120 Base Pinouts
Installing the R120 Wired Remote
1. Plug wired remote into console Aux port (only AUX3 is allowed on older consoles).
2. At Operating Software setup screen set “Handheld Remote” to “R120 Wired” and set the port
that the handheld remote is plugged into.
3. Display will illuminate and keys become active.
4. Channels under remote control will be displayed in purple on console screens.
5. Simultaneously press and hold “.” and “*” keys (2 bottom right keys) to adjust display contrast
using up and down keys.
Installing the R120 Radio Base
1. Plug radio base station into console Aux port (only AUX3 is allowed on older consoles).
2. Red power LED on base will illuminate.
3. At the Console Setup screen Handheld Remote Communications Setup set “Handheld Remote”
to “R120 Radio” and set the Net Node, Port, Baud and Configuration Address.
4. Green TX LED will flash approximately once per second.
Installing the R120 Radio Handheld Remote
file:///C|/LIGHTP/HELP.ENG/page37.htm (2 of 5)11/2/2004 3:02:58 AM