GeniusPro/Lightpalette Operator's Manual - Strand Lighting

CommuniquéPro
GO Acts as a normal GO button and resumes a fade after it has been stopped.
RESUME Starts the next cue; it does not resume the previous fade.
GO CUE #.# Go cue, where #.# is a specific cue (same as CUE #.# GO).
STOP Stops the current fade.
FIRE # Runs user macro # (# from 0 to 127).
LOAD #.# Loads the X playback with cue #.#.
ALL_OFF Blackout on.
RESTORE Blackout off.
RESET & GO_OFF Go Cue 0.
Note: All playback actions take effect only on X playback 1.
MSC output is activated when the MSC ID Tx option in the MIDI Window in the Show Setup
Screen is set to a value between 0 and 127. If the MSC ID Tx is OFF no MSC messages are
transmitted. Received MSC messages are only accepted if the MSC ID Rx matches the
received message ID or the MSC ID is set to 127 (All Call).
Note:Midi Show Control GO_OFF does not run cue 0. Instead use MSC RESET instead. Also,
Midi Show Control does not support playback 2. Instead fire a macro containing the GOX2 key.
MIDI Keys And Faders
All key and fader changes are transmitted via MIDI OUT and received via MIDI IN
simultaneously. This will allow a second desk to be used as a full backup unit or as a slave
unit. It will also allow all key presses and fader movements to be recorded on a sequencer in
real time and played back in real time, in particular, the recording and playback of Cues,
Effects and Submasters.
The Channel option in the MIDI Window in the Show Setup Screen will select the MIDI channel
on which to receive and transmit the key and faders on. When OFF, no key or fader events will
be received or transmitted across MIDI.
The Fader and Key Controller selections (between 1 and 4) select which MIDI General
Purpose Controller is used to transmit and receive keys and faders. For tracking backup and
slaving, the controller numbers must be different. The Mode determines if all keys and faders
are sent (BACKUP) or if only a subset are sent (SLAVE).
MIDI Note
The Midi Note On and Note Off commands are received and used to flash Submasters or
file:///C|/LIGHTP/HELP.ENG/page8.htm (7 of 22)11/2/2004 3:02:24 AM