GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Submasters
[SUB] [1] [FX] [2] [*] (All Modes)
Changes the effect assigned to submaster 1 to effect 2 without changing
any levels.
[SUB] # [MACRO] # records levels on the current display into the specified submaster
and assigns a macro to it. If the submaster has already been recorded, an overrecord
message gives you the chance to cancel the recording. To rerecord the submaster,
press [RECORD] [*] again. To cancel the recording, press [CLR] or [UNDO]. When the
submaster is moved up from zero the macro is automatically started. To delete an
assigned macro, omit the macro number.
[SUB] [1] [MACRO] [3] [RECORD] (Direct 1 Digit and Direct 2 Digit)
[RECORD] [SUB] [1] [MACRO] [3] [*] (Command Line)
Records levels into submaster 1 and assigns Macro 3 to it.
[SUB] [1] [MACRO] [RECORD] (Direct 1 Digit and Direct 2 Digit)
[RECORD] [SUB] [1] [MACRO] [*] (Command Line)
Records levels into submaster 1 and deletes any assigned macro.
[SUB] # [MACRO] # [*] changes the macro assigned to the specified submaster without
changing recorded levels. You do not get an overrecord warning with this command if
the submaster exists.
[SUB] [1] [MACRO] [*] (All Modes)
Deletes the macro assigned to submaster 1 without changing any levels.
[SUB] [1] [MACRO] [2] [*] (All Modes)
Changes the macro assigned to submaster 1 to macro 2 without changing
any levels.
External Faders
The numbered submaster fader normally controls the submaster or supermaster directly. However,
each submaster can be set to use one of the 12 analog inputs from the REMOTE connector, in which
case the fader level is combined with the analog input level on a highest takes precedence basis. Each
analog input can only be used once.
Submaster Bump Modes
file:///C|/LIGHTP/HELP.ENG/page24.htm (10 of 25)11/2/2004 3:02:50 AM