GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Automod
Deleting Auto-Mod Channels
You can delete specified destination channels from the Automod Screen or delete all Automod
pairing using the {DELETE} softkey, as shown:
[3] {DELETE} [*] Deletes the destination channel 30 (All Modes)
Note: Where only one destination channel is paired to one source channel, deleting the
destination channel will clear the source channel from the display (source channel no longer
paired in Automod). Where more than one destination channel is paired to a source channel
and one of the destination channels is deleted, the remaining destination channel(s) will
remain paired to the source channel. You cannot delete source channels from the Automod
Screen.
{AUTOMOD FROM} [3] {DELETE} [*] Deletes source channel 3
{DELETE} {DELETE} Deletes all auto-mod entries from the Auto-Mod Screen
Updating the Show from the Auto-Mod Screen
Automod channels shown on the Automod Screen will remain paired while in the USE
AUTOMOD mode. Pressing the {A-MOD OFF} key will remove the Automod pairing from the
show. You can permanently update cues, subs, groups or effects from the Live screen to
incorporate the pairing set in the AutoMod Screen as shown:
[UPDATE] {UPDATE A-MOD} [CUE] [1] [THRU] [8] [*] Updates cues 1 to 8 from
the Auto-Mod Screen
[UPDATE] {UPDATE A-MOD} [SUB] [2] [THRU] [4] [*] Updates submaster 2 to
4 from Auto- Mod Sceen
[UPDATE] {UPDATE A-MOD} [GROUP] [3] [*] Updates group 3 from the Auto-
Mod Screen
[UPDATE] {UPDATE A-MOD} [FX] [5] [*] Updates effect 5 from the Auto-Mod
Screen
file:///C|/LIGHTP/HELP.ENG/page53.htm (3 of 4)11/2/2004 3:03:13 AM