GeniusPro/Lightpalette Operator's Manual - Strand Lighting

User Setup
complete is shown to the left of this.
Show Last Recorded Cue
When ON (GeniusPro Default), the last recorded cue is shown at the bottom of the X Playback
window of the State display. When OFF (Lightpalette Default), the last recorded cue is not
shown.
Screen Menus
When ON (Lightpalette Default), the centre LCD menu and the right LCD menu (2 Sceens) are
shown at the bottom of the State screen and Levels screen respectively. When OFF
(GeniusPro Default)), they are not shown
Default Times Window
The Default Times window is in the User Setup display, and lets you set the default times for
recording or running cues and effects.
The fields within the Default Times Window are desribed as follows:
■ X Back, Cut
■ Cue Fade Up/Down
■ Cue Delay Up/Down
■ Cue Wait
■ FX Step
■ FX Step In/Dwell/Out
■ FX Up/Down
■ Undo Time
X Back, Cut
The default times when going back to a cue in the X Playback using [STOP/BACK], and
cutting to a cue in an X playback using [CUT] (two separate values). They can be any value
between 0 and 59 minutes 59 seconds, and are initially set to 0/0. Times below one minute
can be specified in the range 0.1 to 59 seconds.
file:///C|/LIGHTP/HELP.ENG/page18.htm (17 of 21)11/2/2004 3:02:40 AM