GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Additional Information
Additional Information
This section covers the following topics:
●
●
●
●
●
●
●
●
●
●
Notes on Upgrading Old Software
Tracking Backup Notes
Fitting RAM Memory
Macro Trigger Card
Tracker Library Files
Site Configuration Files
DOS Utilities
DOS Environment Variables
Country Keyboard Support
Changing the HTML Help Files
Notes on Upgrading Old Software
If your current version of operating software is earlier than 2.0, you need to re-register your
console, and PC, if fitted with a CS card or dongle, in order to use release 2.4.
Important Note: If you are installing over software which is older than 2v0, you must delete
220NET.CFG files, and edit 220NODE.CFG files on all consoles and SN100s to match the
format in 220NODE.NEW supplied with the new software. If you forget to change these,
consoles may not start, and backup PCs may not have control of their keyboard.
Editing the 220NODE.CFG Network Configuration File
All devices used on the ShowNet network must have the following defined:
nodeaddr = 192.168.0.aaa
These are the four decimal numbers of the IP address.
aaa can be 1 to 254
nodetype = 530
For example - see the list of types in the file (See also 220TYPEASCFG enviroment variable)
file:///C|/LIGHTP/HELP.ENG/page51.htm (1 of 9)11/2/2004 3:02:53 AM