GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Recording Cues
Assigning Fade Profiles
Profiles let you change the fade characteristics of cues.
You can assign a profile to the cue, or assign separate profiles to the up fade and down fade.
cue [PROFILE] # [RECORD] Direct 1 and 2 Digit
[RECORD] cue [PROFILE] # [*] Command Line
Records the levels on the current display into the specified cue and assigns a
fade profile to it. If the cue already exists, an overrecord message gives you the
chance to cancel the recording. Press [RECORD] [*] again to record over the cue
or [CLR] or [UNDO] to cancel theoperation. For information on how to create and
edit profiles, refer to Profiles.
If you only enter one fade profile number, it is used for both the up and down fades. To enter
separate up and down fade profiles, use [/] to separate the two numbers. The first number
becomes the up fade profile and the second number becomes the down fade profile.
Separate fade profiles can be assigned to each cue part. To delete an assigned fade profile,
omit the fade profile number. Separate fade profiles can be assigned to each cue part. To
delete an assigned fade profile, omit the fade profile number.
[CUE] [1] [PROFILE] [3] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [PROFILE] [3] [*] Command Line
Records levels into cue 1 and assigns fade profile 3 to both the up and down fades.
[CUE] [1] [PROFILE] [3] [/] [1] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [PROFILE] [3] [/] [1] [*] Command Line
Records levels into cue 1 and assigns fade profile 3 to the up fade and fade profile 1 to the
down fade.
[CUE] [1] [PROFILE] [/] [1] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [PROFILE] [/] [1] [*] Command Line
Records levels into cue 1 and assigns fade profile 1 to the down fade. The up fade profile is
set to 0 if this is a new cue, or left as it is if over-recording.
[CUE] [1] [PROFILE] [3] [/] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [PROFILE] [3] [/] [*] Command Line
Records levels into cue 1 and assigns fade profile 3 to the up fade. The down fade profile is
set to 0 if this is a new cue, or left as it is if over-recording.
[CUE] [1] [PROFILE] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [PROFILE] [*] Command Line
Records levels in cue 1 and deletes any assigned fadeprofiles.
file:///C|/LIGHTP/HELP.ENG/page45.htm (8 of 22)11/2/2004 3:02:32 AM