GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Working with Channel Levels (Cont)
group is linked to the cue, effect step, or submaster into which it is recorded, and changes
made in the group are automatically made to the cue, effect step, or submaster. For more
information about referenced groups, refer to Referenced Groups (Preset Focus) Tracker
Software
Attribute Filters
You can use the Attribute Filters feature to quickly set the levels of selected functions for
fixtures with multiple attributes using referenced groups. (Refer to Attribute Filters)
Using the Level Wheel
If you are in the Live display, moving the Level Wheel masters the intensity levels in the
current selection up or down. The way in which channels are mastered depends on the Wheel
Mastering field in the User Setup Screen. Its value can be SHAFT or PROPORTIONAL.
SHAFT mastering is the default for GeniusPro and PROPORTIONAL mastering is the default
for Lightpalette
The Wheel Sensitivity can also be set up in the User Setup Screen.
Levels cannot be wheeled over 100% (or below 0%) but they will retain their relative
proportions until you clear the selection, so that if you wheel them down again the original
proportions will reappear. For example, with two channels at 10% and 40%, these can both be
wheeled up to 100% and then back down to 10% and 40%.
chans [@] wheel selects the listed channels and lets you master them up or down by the
Level Wheel. To master the current selection, omit chans. The [@] is optional. This is the
same as chans [*] followed by wheel
●
●
[1] [+] [2] wheel All Modes
Makes channels 1 and 2 the current selection and wheels their levels from their current
values.
wheel. The existing current selection is unchanged but their levels are wheeled.
file:///C|/LIGHTP/HELP.ENG/page50.htm (3 of 11)11/2/2004 3:02:45 AM