GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Profiles
more points.
Each end point, and any point you add, is an anchor point for a section of the curve and is
shown in white rather than green. When you add a point, the curve is redrawn so that there is
a straight line between the new point and the nearest anchor point(s).
trackerball or mouse {INSERT POINT} {INSERT POINT} sets an anchor point in the
profile. Anchor points are shown in white. All other points in the profile are calculated to
create straight lines between adjacent anchor points.
trackerball or mouse Highlights the location for the new point. The trackball or mouse
moves the highlight in 5% steps. To change point values in 1% steps, use [+] and [-].
{INSERT POINT} {INSERT POINT} Inserts the point and recalculates all points between
the end points and the new anchor point
{DELETE POINT} {DELETE POINT} deletes an anchor point in the profile. The profile is
recalculated so that there is a straight line between the anchor points on either side of
the deleted point. You cannot delete end points. They are always anchor points.
trackerball or mouse Highlights the point you wish to delete.
{DELETE POINT} {DELETE POINT} Deletes the point and recalculates all points
between the two anchor points that were adjacent to it.
Deleting a Profile
Profiles can be deleted in the Profile display. This is a good way to delete profiles if you are
only going to delete a few. For information on deleting all profiles or a range of profiles from the
Archive display refer to Clear Operations in the Archive Screen
[PROFILE] # {DELETE PROF} [DELETE PROF} or
[PROFILE] # {DELETE PROF} [*] or
Select profile with trackball, mouse, or [NEXT] or [LAST] keys, then [DELETE PROF}
{DELETE PROF}
Deletes the selected specified profile.
Profile Learn
file:///C|/LIGHTP/HELP.ENG/page26.htm (7 of 9)11/2/2004 3:03:08 AM