GeniusPro/Lightpalette Operator's Manual - Strand Lighting

User Setup
[1][@][4][.][5] sets channel 1 to 45%
DIRECT 2 DIGIT Commands are carried out as soon as they are fully entered although the [*]
key is required for some commands. In general, the syntax is object first, then action (for
instance, [CUE][1][RECORD]).
Channel levels are entered as a two digit number.
[1][@][0][2] sets channel 1 to 2%.
[1][@][3][0] sets channel 1 to 30%.
[1][@][4][5] sets channel 1 to 45%.
CC Auto Hold Mode
When ON (Lightpalette Default), channels cannot be “stolen” from the Channel Control by
cues, subs, and effects. When OFF (GeniusPro Default), running a cue or effect, or changing a
submaster level, will steal channels from the Channel Control.
Note: In Lightpalette mode, if a handheld or remote console selects a channel and then
Autohold is switched off, the channel cannot be stolen back by the main console. Switch
Autohold back on, select and deselect the channel using the handheld or remote console, then
switch Autohold off. [SHIFT] [CLR] can then steal the channels.
On Level %
Sets the default on level for use by the Channel Control {ON} command. Levels set in the *On
group (993.1) or the *On Handheld group (993.2) are used if they exist. This number is used
for any channel that is not set in these groups. For further information, refer to Groups
# A number from 0 to 100 (default 100) setting the on level.
Up/Down %
Sets the percent level change that the {UP%} and {DOWN%} softkeys represent.
# A number from 0 to 100 (default 5) giving the percent level change when the {UP%} or
{DOWN%} keys are used.
file:///C|/LIGHTP/HELP.ENG/page18.htm (3 of 21)11/2/2004 3:02:40 AM