GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Networker Software
Sync Connect To Main
Backup is connecting to main
during sync.
Sync Backup Loading Main giving sync.
Sync Backup Saving Main taking sync.
Sync Main Loading Main taking sync.
Sync Main Saving Main giving sync.
Sync Transfer To Backup Main giving sync.
Sync Transfer To Main Main taking sync.
Backup Commands
Backup commands are available if both main and backup powered up with the state Main OK Backup
OK No Sync displayed. If states such as Main (or Backup) Gone Offline, or Main (or Backup) Not
Found are displayed, these commands are not available.
Backup commands are accessed by pressing [MORE]{BACKUP CMDS} , revealing the following
set of soft keys:-
{M GIVE SYNC}, {M TAKE SYNC}, {M GIVE CTRL}, {M TAKE CTRL}, {BREAK SYNC} and {RESET
DESK}
{M GIVE SYNC}
Main give sync to backup: the current show is transferred to the backup and only the main’s outputs
are enabled.
State sequence:
●
●
●
●
●
Sync Transfer To Backup
Sync Backup Loading (if the sync fails for any reason here, see Shifted Backup commands
below)
Sync Connect To Backup
Sync Connect To Main
Main Active In Sync.
file:///C|/LIGHTP/HELP.ENG/page15.htm (16 of 23)11/2/2004 3:02:29 AM