GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Effects
[FX] [1] {STEP CTR} {AUDIO} [*]
Sets FX 1 step control to Audio
Step Default Values
Step Default Values are the values initially set for the effect step properties. When you create a new
step, these values are applied. You can change values for any individual step if required. Changing the
default value changes the value for the property in all steps where it has not been specifically
overridden. Step properties at their default values are shown in black text. Step properties that have
been overridden are shown in green text. You can set default values for all of the step properties.
Recording Effect Step Properties
Individual effect steps have the following properties that can be specified when recording, or edited
later:
❍
❍
❍
❍
Step Time Field
In, Dwell, and Out Times Field
Attribute Fade Time Field
Low and High Scaling Field
These properties apply to each effect step individually. Effects as a whole also have properties,
including the default values for steps.
When you create a step, all step properties take on the values set in the Step Defaults for the effect.
These defaults are set from the The Default Times Window of the User Setup Screen when you create
the effect. All step values that you don’t change will automatically track the Step Defaults values. Step
properties that you have modified in the step will not change when you change the Step Defaults, even
if you reset them to the current Step Defaults value.
To set a property back to its “default” (black text), use the trackball to highlight it and then press
{DEFLT}
file:///C|/LIGHTP/HELP.ENG/page35.htm (11 of 34)11/2/2004 3:03:13 AM