GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Common Commands QR
Selects attribute channels 1, 2, 3 then
[1][THRU][3][@ATT][*][LAST]
selects the previous attribute channel (e.
g. channel 2 if this has
attributes)
[4][.][5][THRU][7] Attribute channels 4.5, 5.5, 6.5, 7.5
[3][.][3][THRU][4][.][4] Attribute channels 3.3, 3.4, 4.3, 4.4
[UNDO] [*]
Returns to state before channel changes
[CLR]
Clears the last entered key when a
command is being entered
[SHIFT] [CLR]
Clears the complete command line when
a command is being entered.
[SHIFT] [PAGE UP]
Select 1st Channel Display page
[SHIFT] [PAGE DOWN]
Select last Channel Display page
Selecting Channels in Cues, Groups and Subs (All Modes)
The following commands are common to Command Line and Direct Action modes for
GeniusPro and Lightpalette.
Key Sequence Action
[CUE][1] Channels in cue 1
[GROUP][9] Channels in group 9
[SUB][1]
Channels in submaster 1 in current page
[CUE][1][+][SUB][[2][+][GROUP][ 5]
HTP Sum of channels in cue, submaster
& group
[GROUP][3][THRU][6]
HTP Sum of channels in groups 3 to 6
inclusive
Selecting Displays (All Modes)
The following commands are common to Command Line and Direct Action modes for
GeniusPro and Lightpalette.
file:///C|/LIGHTP/HELP.ENG/page54.htm (10 of 19)11/2/2004 3:03:26 AM