GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Show Setup Screen
combined on a latest takes precedence basis.
Auto Move While Dark
When ON, scrollers and other moving fixtures move to new positions at the end of a cue while the
fixtures are dark.
Its value is OFF (default) or ON.
The console looks ahead to the next cue to see which fixtures (if any) have attribute changes, and
makes the attribute change while those fixtures are still dark. You can set the speed for the change in
the Fade field and the delay in the Delay field to the right of this field.
Auto Move Fade/Delay
Sets the speed for the auto move (Fade) and the delay between the end of the last cue and when the
auto move will start.
The default values are 1/1
Auto Preheat
When ON, channels with intensities higher in the next cue than in the *Preheat group (999.5) are faded
to the levels in the *Preheat group when a cue is loaded. This lets you “preheat” large wattage fixtures
so that they fade up smoothly.
Its value is OFF (default) or ON.
Auto Preheat Fade/Delay
Sets the speed for the fade to the preheat level and the delay between the end of the last cue and
when the preheat fade starts. You can set the speed for the fade in the Fade field and the delay in the
Delay field to the right of this field.
The default values are 1/1.
Power Up Restore
At power up, this restores the output channels to the levels that were present in the Live display when
the console was powered off. Otherwise, the console output levels are all set to 0% at power up.
Its value is OFF or ON (default).
file:///C|/LIGHTP/HELP.ENG/page22.htm (4 of 10)11/2/2004 3:02:30 AM