GeniusPro/Lightpalette Operator's Manual - Strand Lighting

User Setup
■
■
■
Display Options Window
Default Times Window
Console Window
Control Modes Window
The Control Modes window is in the User Setup display, and lets you configure how channels
are controlled.
The fields within the Control Modes Window are desribed as follows:
■ Channel Control Mode
■ CC Auto Hold Mode
■ On Level %
■ Up/Down %
■ Wheel Mastering
■ Wheel Sensitivity
■ Stop Key
Channel Control Mode
Controls the channel command syntax accepted by the console.
Its value is COMMAND LINE, DIRECT 1 DIGIT, or DIRECT 2 DIGIT.
COMMAND LINE (Lightpalette Default) Commands are mainly only carried out after you press
[*] , although it is sometimes not required. In general, the syntax is action first, then object (for
instance, [RECORD][CUE][1][*] ).
Channel levels are entered as a single digit number which represents a multiple of 10% or a
double digit number which lets you enter fractions of 10%.
[1][@][0][2][*] sets channel 1 to 2%.
[1][@][3][*] sets channel 1 to 30%.
[1][@][4][5][*] sets channel 1 to 45%.
DIRECT 1 DIGIT (GeniusPro Default) Commands are carried out as soon as they are fully
entered although the [*] key is required for some commands. In general, the syntax is object
first, then action (for instance, [CUE][1][RECORD]).
Channel levels are entered as a single digit number which represents a multiple of 10%. This
can be followed by . and a second digit for fractions of 10%.
[1][@][0][.][2] sets channel 1 to 2%.
[1][@][3] sets channel 1 to 30%.
file:///C|/LIGHTP/HELP.ENG/page18.htm (2 of 21)11/2/2004 3:02:40 AM