GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Common Commands QR
[CLR]
[CLR]
[SHIFT] [CLR]
[SHIFT] [CLR]
[SHIFT] [*]
[SHIFT] [*]
Command line not empty: clear last key
Command line empty: clear current
selection
Command line not empty: clears whole
command line
Command line empty: steals control back
from other consoles or handhelds.
Command mode: Restore last command
line for editing
Direct mode: Repeat last command
Selecting and Displaying Channels (All Modes)
The following commands are common to Command Line and Direct Action modes for
GeniusPro and Lightpalette.
Key Sequence Action
[*] Channels with levels > 0
[1] Channel 1
[1][+][3] Adds channels 1 and 3 to the channel list.
[1][THRU][3][-][2]
Adds channels 1 and 3 to the channel list.
[1][THRU][LAST]
Puts all channels on the channel list.
[1][THRU][2][+][6][THRU][7]
Adds channels 1, 2, 6, and 7 to the
channel list
[1]{THRU ON}[3]
Adds channels 1, 2, and 3 to the channel
list if they are on
[SHIFT] [THRU]
= {THRU ON}
[+][4][THRU][9]
Adds channel 4 through 9 to the existing
channel selection.
Selects channels 1, 2, 3, adjusts them to
[1][THRU][3][*] Wheel [NEXT]
the desired level, and then selects the
next intensity channel
(channel 4 in this case).
Selects the next intensity channel after
[1]{THRU ON}[3][NEXT]
channel 3 regardless of whether channel
3 is on.
file:///C|/LIGHTP/HELP.ENG/page54.htm (9 of 19)11/2/2004 3:03:26 AM