GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Macros
Pre-Assigned Macros
There are up to 3000 macros numbered 0 to 2999. Macros 951 to 964 are reserved as macros P1 to
P14. You can access these macros directly using [P1] through [P14], or through the numeric keypad
as macros 951 to 964.
Macros 971 to 984 are reserved as macros SP1 to SP14. You can access these macros directly using
[SHIFT] [P1] through [SHIFT] [P14], or through the numeric keypad as macros 971 to 984.
Keys [P8] through [P14] and [SHIFT] [P8] through [SHIFT] [P14], are available only on 520 and 300
series consoles. However you can access these macros from the keyboard on 530 and 550 consoles
using 958 to 964 and 978 to 984 respectively.
Macros 991 to 996 are reserved as macros LCD1 to LCD6. You can access these macros directly
through the centre LCD buttons (or the first four through the four centre unlabelled keys in consoles
with only 2 LCD displays), or through the numeric keypad as macros 991 to 996.
Macro 998 is reserved for the USER macro. You can access this macro directly using [USER], or
through the numeric keypad as macro 998.
Macro 999 is reserved for the SUSR macro. You can access this macro directly using [SHIFT]
[USER], or through the numeric keypad as macro 999.
Macros 891 to 894 are reserved as HHM1 to HHM4, for the functon keys F1 to F4 on R120, R130
Remote Handheld Units. HHM1 to HHM3 only can be fired from F1 to F3 on a Designer's Remote
Hand-Held units.
The twelve keys on the front of a 300 Series LCD Monitor are used to fire preset macros. The number
of LCD monitors fitted is detected by the software and the preset macros reserved as follows:
1 LCD Monitor - 12 macros numbered 901 - 912 V1 - V12
2 LCD Monitors - 24 macros numbered 901 - 924 V1 - V24
3 LCD Monitors - 36 macros numbered 901 - 936 V1 - V36
4 LCD Monitors - 48 macros numbered 901- 948 V1 - V48
Note: after loading from a pre version 2.0 show file, the macro key macros may go to the wrong place
as follows:
Original P1-7 (macros 991-997) becomes LCD1-6 and 997
Original LCD1-6 (macros 981 -986) becomes SP11-14, 985, 986
Original SP1-7 (macros 971-977) remain the same
Original USER (998) remains the same.
file:///C|/LIGHTP/HELP.ENG/page30.htm (2 of 10)11/2/2004 3:02:58 AM