GeniusPro/Lightpalette Operator's Manual - Strand Lighting

R120 Handheld Remote
1. Connect radio handheld to power supply for 12 hours to achieve full charge.
2. Press “On” key (top right) to power up handheld unit.
3. Display should illuminate and keys become active.
4. Handheld will display ‘ Unit Address n” for approximately 3 seconds. Change the unit address to
match the address set at the console by pressing number keys 1 to 8 within first 3 seconds.
Adjust display contrast using up and down keys.
5. Unit address and contrast can be changed at any time by simultaneously pressing and holding
“.” and “*” keys (2 bottom right keys).
6. Channels under remote control will be displayed in purple on console screens.
7. Unit auto powers down after a period of inactivity or can be manually powered down by
simultaneously pressing and holding “.” and “*” keys (2 bottom right keys) then pressing “On”
key (top right).
8. Unit will “beep” every 3 seconds when battery power is low and recharge required.
R120 Base Pinouts
6 pin XLR male RS232 Signal Name
Pin 1 Ground & Screen
Pin 2 +10V Power Input
Pin 3 N/C
Pin 4 N/C
Pin 5 RX [data to base/handheld]
Pin 6 TX [data from base/handheld]
Operating the R120 Handheld Remote
Examples of basic operation when in Single Digit Direct Entry mode are given below. For further
details regarding specific commands, refer to the appropriate section in the Table of Contents or Index.
Level Setting
[1 ][@][ 5] Direct 1 Digit
[1][@][50][*] Command Line
channel 1 at 50%
[2][+][9][@][4] Direct 1 Digit
[2][+][9][@][4][0][*] Command Line
channels 2 & 9 at 40%
file:///C|/LIGHTP/HELP.ENG/page37.htm (3 of 5)11/2/2004 3:02:58 AM