GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Effects
Next Fx The next effect to be started when this effect stops. Only applies to effects where the Stop
After field is set to TIMED or CYCLES. Can be OFF or an effect number.
Fade Up The time it takes the effect to fade in after you press [FX GO]. Can be from 0 to 59 minutes,
59 seconds.
Fade Dn The time it takes the effect (not an effect step) to fade out after you press [FX STOP]. Can be
from 0 to 59 minutes, 59 seconds.
Profile The profile assigned to the effect fade times. Applies to both the fade up and fade down times.
Stop After How the effect will stopped. Can be one of FX STOP (on Fx stop), FX LOAD (on Fx load),
LAST STEP (on last step), TIME (after XXX seconds), or CYCLES (after XXX cycles). For CYCLES
set the number of cycles in the Cycles field. For TIME set the time in the Time field.
Step Control The way steps are started. Can be one of TIMED, MANUAL, MIDI, or AUDIO.
Step DefaultsThe values that will be assigned to step properties when you create a step. These
values can be changed if necessary after the step is created. Included fields for step time (Step TIME),
step in, dwell, and out times (In/Dwell/Out), attribute fade time (Att), step low and high values (Low/
High), and scaling (Scaling). Scaling is not implemented at this time.
Effect Step Fields
Fields in the Effect display FX Step window show the current values for effect step properties. The
property associated with each display field is indicated by the title line.
To change any of the effect step properties:
1. Make sure that the highlight is in the lower part of the State display (press [EDIT STEPS] if it
isn’t).
2. Use the Trackball to move the highlight to the field you want to change.
3. Type a new value or use [+] and [-] to increment or decrement the value. The new value is
recorded when you move the highlighting out of the field.
To move between steps, use the Trackball to move the highlight to the FX Step field and then use
[NEXT] and [LAST] to move between steps.
FX Step The number of the effect step. These are fixed and cannot be changed.
Step Time Step time for the step.
file:///C|/LIGHTP/HELP.ENG/page35.htm (30 of 34)11/2/2004 3:03:13 AM