GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Patching QR
[1] [THRU] [5] [@] [1] [0] [THRU] [1] [4]
Patches channels 10 - 14 to outputs 1
- 5
[1] [THRU] [5] [@] [1] [4] [THRU] [1] [0]
[1] [THRU] [2] [0] [@] [4] [THRU] [8]
{@FIXTURE} [1]
Patches channels 14 - 10 to outputs 1
- 5
Patches outputs 1 to 20 to channels 1
to 8 and patches fixture 1 to each
patch.
[1] [THRU] [2] [0] [@] [8] [THRU] [4] {A
FIXTURE} [1]
Patches outputs 1 to 20 to channels 8
to 1 and patches fixture 1 to each
patch
Customising the Patch Display
The following commands are common to Command Line and Direct Action modes for
GeniusPro and Lightpalette.
Key Sequence Action
Changes the Patch display between
showing standard output numbers and
{SET} (DMX/OUTPUT}
showing output numbers in Universe.
Dmx format
{SET} {SET DISP}
Show the Patch display in output order
{OUTPUT ORDER}
{SET} {SET DISP} {CHAN
ORDER}
{SET} {SET DISP}
{LOADS ON}
{SET} {SET DISP}
{LOADS OFF}
Shows the Patch display in channel
order.
Displays Learned Loads for outputs or
channels.
Displays Threshold values for outputs or
channels.
Deleting Channels
The following commands are common to Command Line and Direct Action modes for
GeniusPro and Lightpalette.
file:///C|/LIGHTP/HELP.ENG/page59.htm (5 of 6)11/2/2004 3:03:27 AM