GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Patches
command. Press [*] again.
[1] {SWAP PATCH} [1] [0] [*]
Swaps attributes on output 1 and 10
[1] [THRU] [8] {SWAP PATCH} [1] [7] [*]
Swaps attributes on outputs 1 to 8 with attributes on the eight outputs starting on output 17.
Press {BACK} to return to the LCD Patch menu.
Swapping Fixtures
The position of individual fixtures, or a range of fixtures can be swapped by entering the
outputs used by the fixture to be swapped and the first output used by the fixture that it has to
be swapped with.
Note:The fixture, or range of fixtures, using the most number of outputs must be entered first.
Press {SET} {COPY/SWAP} to display the Copy Patch Menu, then enter the output number,
or range of outputs, of the fixtures(s) to be swapped, followed by the {SWAP PATCH} softkey
and first output number of the fixture, or range of fixtures, to be swapped with, then [*]. A
confirmation is requested after each command. Press [*] again.
The following example assumes that a PALS Piouette 16 is patched to outputs 25 through 28
and a PALS Pirouette is patched to outputs 9 through 12
[2] [5] [THRU] [3] [0] {SWAP PATCH} [9] [*]
Swaps a PALS Pirouette 16, patched to outputs 25 through 30 with a PALS
Pirouette, patched to outputs 9 through 12.
Press {BACK} to return to the LCD Patch menu.
Note:The required number of outputs must be available in the ‘swap to’ position, otherwise, the
swap cannot take place and an invalid range error message displayed. If say, an eight output
fixture is being swapped with a six output fixture, all eight outputs will be swapped, including
any attributes on the other two outputs.
Changing the Output Numbering Style
To change the Patch display between showing standard output numbers and showing output
numbers in Universe.Dmx format, press {DMX OUTPUT}
file:///C|/LIGHTP/HELP.ENG/page9.htm (12 of 21)11/2/2004 3:03:09 AM