ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

• P1
Exporting Layouts
‘Data Format’ Tab (TIFF, TIFF/IT)
Creates documents that comply with the TIFF/IT-P1 standard (no
compression allowed).
• P2
Creates documents that comply with the TIFF/IT-P2 standard, which
allows compression. However, spot color output is not yet supported.
• LINOTYPE/HELL
Use this setting for documents that will be further processed by
Linotype/HELL systems. These systems may require additional information
in the TIFF/IT documents. However, this causes the documents
to be no longer TIFF/IT P1 or P2 compliant.
• P1 (NO LONG RUNS)
Use this setting for documents that will be further processed by
DaVinci systems. Output documents will be TIFF/IT-P1 compliant,
but the LW file is created in a different format (without any ‘long runs’).
DaVinci systems do not seem to support TITT/IT linework with socalled
‘long runs’, although ‘long runs’ comply with the P1 specification.
Note that the size of the LW file increases if this setting is used.
Image compression
Use this parameter to compress the TIFF output file or the CT portion of
TIFF/IT-P2 documents. You can select between the following methods:
• LZW (lossless)
• ZIP (lossless)
• JPEG (lossy)
Use the QUALITY and FILE SIZE parameters to select the JPEG compression
level.
Quality
http://www.image2output.com
Determine the JPEG image quality by either entering a number or selecting
a quality level from the list:
LOW 0–4
MIDDLE 5–7
HIGH 8–9
MAXIMUM 10–12
The lower the quality, the higher the compression level and the smaller
the file size.
ORIS PDF Tuner Version 4.4.8 User Manual 3-23
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com