ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Transformations
Positioning Objects Accurately
3. To end the function, reselect the button, click on the layout or select
another function from the TRANSFORMATIONS toolbar.
This fixed point is now used for all transformations applied to this object
until you leave the transformation function.
Note: If the object has been distorted using , the fixed point is automatically
set on the lower left corner of the object or its bounding box. If this occurs
you can change the fixed point at any time as described above.
Fig. 19-6
Indication of Fixed Point
Fixed point
(e.g pivot)
Guide points
Allow fixed point to be
positioned precisely
Positioning Objects Accurately
1. Click on the button.
Four points connected by lines are displayed. By
default, the point in the lower left corner (marked
by a frame) is active and can be positioned.
2. If you want to use another of the four points, click this point twice.
Note: Make sure the active point is represented as an empty square . If it
is a filled square , the point is locked and the object will be distorted.
You can also use the tool to set the four points on another positions.
Refer to Specifying Points for Positioning/Distorting (page
19-19).
3. Take one of the following actions:
• To position the point on a specific coordinate (e.g. 0/0), enter the
values on the keyboard (press RETURN/ENTER after each input).
The MANUAL ENTRY dialog appears automatically and the values
you enter are displayed there (direct input, see page 29-7).
ORIS PDF Tuner Version 4.4.8 User Manual 19-15
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com