ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Exporting Layouts
Using Bleed Pages
Fig. 3-29
Original Page
Merging a Layout with a Bleed Page
Bleed Page
A
A
D
E
D
C
C
E
B
B
The layers on the bleed page are positioned as follows in this example:
A
Bleed Page
Layers
Variables
($Job…) at
the top
Positioning
Method
Absolute
(layers not
marked)
Position on Output Document
Layers are shifted to the left, because the distance
to the lower left corner of the page area is
the same as on the bleed page, but the actual
page is larger than the bleed page.
B
Variables
($Job…) at
the bottom
Relative
(marked)
No shift. The distance between the layer and the
area corner is enlarged according to the difference
in size between the two pages.
C
Register/
crop marks,
DEMO
Relative
(marked)
Ditto. The layers are therefore always in the
corner or center of their respective area.
D
CGS logo on
the left
Relative
(marked)
The three layers that constitute the logo have
drifted apart, because the position was recalculated
individually for each of these layers.
To avoid this, use logos that consist of a single
image instead of multiple layers.
E
CGS logo on
the right
Absolute (not
marked)
The three layers remain together, but are shifted
to the bottom, because the distance to the area
corner is the same as on the bleed page (which
is smaller).
ORIS PDF Tuner Version 4.4.8 User Manual 3-65
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com